Display statististics for Internet Protocol Security (IPsec) for an VLAN interface.
show ipsec statistics vlan <1-4059>
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
None
User EXEC
The show ipsec statistics vlan command displays the following information:
|
Output field |
Description |
|---|---|
|
Ifindex |
Specifies the interface. |
|
InSuccesses |
Specifies the number of ingress packets IPsec successfully carries. |
|
InSPViolations |
Specifies the number of ingress packets IPsec discards since boot time because of a security policy violation. |
|
InNotEnoughMemories |
Specifies the number of ingress packets IPsec discards since boot time because not enough memory is available. |
|
InAHESPReplays |
Specifies the number of ingress packets IPsec discards since boot time because the encapsulating security payload (ESP) replay check fails. |
|
InAHFailures |
Specifies the number of ingress packets IPsec discards since boot time because the AH authentication check fails. |
|
InESPFailures |
Specifies the number of ingress packets IPsec discards since boot time because the ESP authentication check fails. |
|
OutSuccesses |
Specifies the number of egress packets IPsec successfully carries since boot time. |
|
OutSPViolations |
Specifies the number of egress packets IPsec discards since boot time because a security policy violation occurs. |
|
OutNotEnoughMemories |
Specifies the number of egress packets IPsec discards since boot time because not enough memory is available since boot time. |
|
generalError |
Specifies a general error. |